Tech Forum

Most times when I connect to the PDM 28 offline and then go to look at my fans that are controlled by the PWM duty cycle graph they show zeroed out even though I just loaded the saved configuration from the computer. Is there something I need to do differently?

Hi, I am currently having a problem with my PDM15 where the 5v output is only outputting 0.015v, my ignition input is on and working, can bus system and all other outputs works perfectly. Any help would be greatly appreciated.

Hi, I've just done a couple of test crimps on test wire for my PDM install and find the quality of the crimp is dire. I am using IWC-1424A crimper which appears as the correct one for Open Barrel Deutsche on my research: ... and ending up with a good crimp on the wire itself but distorted on the cable outer, the legs bend back and not into the cable outer : Anyone confirm that I am using the correct crimper and advise which one if I am not please? Alternatively, I have plenty of the closed barrel deutsche crimps which use a lovely 4 side crimper, can I use these instead? Need to get this right before I start on the car loom. Thanks in advance.