For the CAN input, are there any side effects to it being negative 1?
1) if i set it to 1000 and not send a continuous frame output turns off after 1 second.
2) if i set it to 0 it remains at default value indefinately, even when i send frame to enable it.
3) setting timeout to -1 for CAN input seems to allow the CAN data frame to trigger a latch mode which doesnt require persistant frames to keep active, basically, 1 frame to turn on, and one to turn off.
is this the intended way to use latching outputs?
Please refer to the instructions or hover over the label for a description of what the timeout value does.