We have a PDM 25 linked via Canbus to Fueltech FT550 & BM 12 button keypad. All new install. Task is to turn over engine to build up Oil Pressure. No fuel pump etc enabled.
A keypad button has been allocated as a Start/Stop button set to Momentary.
The output has been set to CAN Keypad 1 Button 7 (Start_Stop) State Equals True.
When you press the button it starts to turn over the engine but restarts the keypad and ECU. Any advise to why it is doing this.
Many thanks.
Set your logic function to be battery voltage >6
Is the PDM on it's own 12 cable Not shared with anything? I had mine sharing power with just a couple things and this was enough to do what your saying. It would start cranking then reset the PDM and had to start over.
Hi,
Please can you check your CAN TEC and REC values in the monitor tab. Please can you also make sure that the battery is good and that it isnt dropping really low when you start to crank.