Hi,
My Setup is that I have a Maxxecu Race, a PDM15 and a BlinkMarine Keypad
Maxxecu wants to use the J1939 protocol. It can (?) use the CanOpen also, maybe?
PDM15 uses CanOpen, and cannot use J1939
Keypad can use both
Right now I have Maxxecu in J1939 and Keypad in J1939. With that I have communication between Maxxecu and the keypad working.
However I would need to get info from the keypad to the PDM somehow. Either to have the PDM read the messages on the canbus from the Keypad or through Maxxecu
I have loaded the Maxxecu can config into the PDM and from looking at the monitor, it looks like messages are coming in. Referring to the video about Fueltech the 'progressbars' are not timing out
So the question: With this setup, would I need to have the Maxxecu and Keypad talk to each other, and then send the data over to the PDM from maxxecu? Or is there any way to get them all to talk on the same canbus ..? So I can get the PDM and keypad to talk directly
I´m guessing others have setup maxxecu with a pdm15 since the configfile is in the downloads ..
Thank you everyone for explaining to Otto what his options are. As has been stated, you can go about it in two ways. Keypad to ECU communication with data relaying to the PDM, or Keypad to PDM communication with data relaying to the ECU.
If you have trouble with either method, just let me know and i can help you out.