Sorry if this is a duplicate as I swear I have read something similar but could not find it. I have the PDM 25, a 15 button Keypad, and a FT550. I am reading data from the FT550 into the PDM and have the keypad connected and can see that in the PDM. I would like to setup the CAN output of the PDM to allow the FT550 to read messages like they have been sent from the mini-8 keypad. I assume Fueltech doesn't do much with the keypads they brand and it's just standard keypad messages with a certain ID. Any pointers in the right direction would be appreciated.
Josh
Thank you very much, that is exactly what I needed. The notes say that the periodic is sent every 1 second so I made that change. Since I am using the keypad for start stop I also added a triggered output that mirrors the output below but have it trigger on the start button state change. If you had any other buttons that you would want to immediately send you could just add additional trigger output.
One note of caution. In the FT Manager software the switchpanel shows up as being on the CAN bus now, which is awesome. However, there are no serial number, versions, or other listed there. At some point I may want to find the right message to send to update that, but everything works as expected so it's low priority.
Thanks again everyone for your help.