I'd like to have a permanently live ~5v output, so assumed I could use a 'Battery Voltage => 12' trigger and PWM. The first is easy enough, but the PWM settings are confusing. The part that gets me is that when I enter 12 in the 40% slot and save, the rest of the slots above 40 also inherit this 12 value. And since the battery voltage is always >12, the output follows the main voltage.
How do I tell the PDM25+ to set an output to ~5v (40%) and stay there?
- Jason
I had the same issue. One off the problems is the PDM keeps seeing a different voltage. I tried so many ways to attempt the stablize the 5v. But i couldn't i was impossible the output would vary from .5 to 9 volts and be all over the place. So I ended up buying a cheap 12 to 5v step down. Only about £3 and does the job for all the sensors.