Hi
Ecumaster uses blinkmarine keypad.
Ecumaster can tool says its canopen, so i think its same what pdm suports as blinkmarine but can't see any communication.
I can send and recive same messages what are in blinkmarine instruction manual.
Or am i wrong and ecumaster have did something to it that so pdm wont suport that keypad ?
Thank you for the extra information. Please could you try and set up a CAN bus output on the PDM to send at 5Hz. It doesn't matter what data or ID you use, just make sure the ID is different to what is already being used on the bus. Please check to see if thenl PDM is sending CAN messages correctly.
I tried can communication between ecumaster emu black also.
Downloaded can config filw from website and sent do pdm, and in emu enebled data stream by canbus.
I can see in emu that 11% canbus load, kbps is same 500, base id is 0x600 , 1536 decimals.
CAN tool sees data messages, but pdm can/tec, rec still 0.
I'm so confused what i m doing wrong. :D
That seems like the default ID yes.
If you are on v114 firmware, please can you go to the monitor tab and global and check what the CAN TEC/REC values are?
Hi Oliver, I believe that everything should work ok. I am not sure what base ID and baud rate ECU Master spec their keypads to come as, so that may be the problem. CAN the ECU Master CAN tool log the CAN data which comes from the keypad as soon as you turn it on? If so, then i can tell you the ID based on the first message it sends.