I am looking to run a input from my brake light switch to the PDM 25 as well as a input from my turn signal switch, but I’m not sure how to program the output, I have one wire to each tail light, one right side and one left, I need the turn signals to work even with The brake lights on. How would I go about programming this if possible ?
top of page
To test this feature, visit your live site.
Brake lights with integrated turn signals
Brake lights with integrated turn signals
1 answer0 replies
Like
1 Comment
bottom of page
Hi,
Here is how you might go about setting that up in the configuration software.
First set up your inputs so that they trigger when the switches are pressed. You can verify this in the monitor tab, the input will turn green when active.
Now set up an on off timer which is what is used to flash the turn signals.
If you don't have a hazard light switch, then you can configure the light like this. The same should be repeated for the right side too.
If you have a hazard light switch, then you can configure the light like this. The same should be repeated on the right side too.
If you have any problems then let me know. The most important thing is to verify that your inputs are configured correctly first.
Kind regards,
George